How to replace the water filter cartridge

How to replace a cartridge filter on your water filter system water at home. This article describes how to change both filters on a filter Aquasana AQ4000 system.

Some of this information may be useful for any brand of filter system. Unpack the kit to replace the filter and check the contents. You should see 2 Replacement Cartridges Water Filter, A and B. Two Spare O-rings. If the O-rings do not lie flat, are and see if they can be carried flat on it's ownduring the night. If this does not work, put a book on it during the night. The reason is that when the O-rings are bent by the expedition makes it difficult to make a good seal.

Water Filter

The first step is to put your home water-filtration systems on the page. You can see the filter caps are marked A and B, arrows so that they are going to solve any kind of cap. Unscrew the filter cap to turn right and shows the direction of the arrow. B filter cap should be loose on the left side or the direction of the arrow.One can only shake hands. If they are too tight to remove by hand using the handles of the pliers, using a little 'more. Make sure that any damage to the entrance or exit for water pipes.

A water filter cartridge removes the most difficult. The seal at the top of the filter keeps the cartridge in place. There is not enough space in the filter box to form a suspension. I think it's easy to use pliers to grab one of the filters and turn and pullout. Water Filter Cartridge B will be attached to the filter cap. Just twist and pull the two pieces. I put the filter on each side of the airbox. This helps you keep track of filter A and B. Remove the two O-rings ensure that the grove, where they sit in is clean. Now install the two new O-rings. Apply a small amount of silicone lubricant food in the exposed area of ​​each O-ring. This helps with the installation of filter capacitors. The oil can easily slide the cover on the tire,that it is easier to seal it. Install dry-fold and may distribute what they have a loss.

Replacing the water filter cartridge A is white. To install it in the cartridge housing the O-ring in the first order. He put some water on the rubber seal that slide easier. Give it a push and turn until it is seated. The replacement cartridge B is blue. Install the O-ring in the cap of the filter. In the same way as the other filters. At this point, I can control theO-rings to ensure they are still in force. Then go ahead and install the filters in the BB frame. Tighten the cap until it is firmly B. Now check the second seal and install the plug in firmly until it is.

Keep it off the filter system on its side in the water and turn the diverter valve. Check the threads around the cap for signs of water. If it is a small leak, try tightening the cap a little 'more. If this does not seal the leak, then open the lid and check theO-ring could be released from its seat check to see if it will not be cut or damaged. If so, you may close the old O-rings. The other option is one of the old seals to your local hardware store to accept and adapt to them. The step, if none of these ideas is to work to get a replacement seal around. Now you can reinstall the cap, as described above and there are no leaks.

If you do not see any leaks run make AQ-4000 water right and leave for 2-3 minutes until the waterclear. The cloudy water can go out on a first or even black, this is normal. Coal dust is cleaned from the filter cartridge. I save the water used to flush the filter system. Indoor plants such as water, on plants or put aside. How to track when you install the time for the next series of new water filters. Write the date subsequent replacement of a piece of tape and put it on the filter. This helps you keep track of time. They must be replaced every 6Months or 500 gallons on water filtration system at home.

How to replace the water filter cartridge

iphone 4 case holster combo ceramic tile distributors nashville